Peer networks at school and students' position in these networks can influence their academic well-being. We study here individual students' network position (isolation, popularity, social activity) and peer network structures at the school level (centralization, density, clustering, school connectedness) and their relations to students' academic well-being (school burnout, SB; schoolwork engagement, SE). Classroom surveys for 14-16-year-olds (N = 11,015) were conducted in six European cities (SILNE survey). Students were asked to nominate up to five schoolmates with whom they preferred to do schoolwork. SB and SE correlated negatively (-0.32; p less then 0.0001). Students had on average 3.4 incoming (popularity; range 0-5) and 3.4 outgoing (social activity; 0-5) social ties. Percentage of isolated students was 1.4. Students' network position was associated weakly with academic well-being-popular students had less SB and higher SE, and socially active students had higher SE. School-level peer networks showed high clustering and school connectedness, but low density and low centralization. Clustering was associated with higher SB. Low centralization and high school connectedness protected from SB. Dense networks supported SE as did high average school connectedness. Correlations between these network indicators and academic well-being were, however, low. Our study showed that both students' network position and network characteristics at the school level can influence adolescents' academic well-being.Cystic fibrosis (CF), caused by biallelic inactivating mutations in the cystic fibrosis transmembrane conductance regulator (CFTR) gene, has recently been categorized as a familial colorectal cancer (CRC) syndrome. CF patients are highly susceptible to early, aggressive colorectal tumor development. Endoscopic screening studies have revealed that by the age of forty 50% of CF patients will develop adenomas, with 25% developing aggressive advanced adenomas, some of which will have already advanced to adenocarcinomas. This enhanced risk has led to new CF colorectal cancer screening recommendations, lowering the initiation of endoscopic screening to age forty in CF patients, and to age thirty in organ transplant recipients. The enhanced risk for CRC also extends to the millions of people (more than 10 million in the US) who are heterozygous carriers of CFTR gene mutations. Further, lowered expression of CFTR is reported in sporadic CRC, where downregulation of CFTR is associated with poor survival. Mechanisms underlying the actions of CFTR as a tumor suppressor are not clearly understood. Dysregulation of Wnt/β-catenin signaling and disruption of intestinal stem cell homeostasis and intestinal barrier integrity, as well as intestinal dysbiosis, immune cell infiltration, stress responses, and intestinal inflammation have all been reported in human CF patients and in animal models. Notably, the development of new drug modalities to treat non-gastrointestinal pathologies in CF patients, especially pulmonary disease, offers hope that these drugs could be repurposed for gastrointestinal cancers.The presence of impurities can drastically affect the efficacy and safety of pharmaceutical entities. p-Aminophenol (PAP) is one of the main impurities of paracetamol (PA) that can potentially show toxic effects such as maternal toxicity and nephrotoxicity. The removal of PAP from PA is challenging and difficult to achieve through regular crystallization approaches. In this regard, we report four new salts of PAP with salicylic acid (SA), oxalic acid (OX), l-tartaric acid (TA), and (1S)-(+)-10-camphorsulfonic acid (CSA). All the PAP salts were analyzed using single-crystal X-ray diffraction, powder X-ray diffraction, infrared spectroscopy, differential scanning calorimetry, and thermogravimetric analysis. The presence of minute amounts of PAP in paracetamol solids gives a dark color to the product that was difficult to remove through crystallization. In our study, we found that the addition of small quantities of the aforementioned acids helps to remove PAP from PA during the filtration and washings. This shows that salt formation could be used to efficiently remove challenging impurities.Background As part of the efforts to find natural alternatives for cancer treatment and to overcome the barriers of cellular resistance to chemotherapeutic agents, polymeric nanocapsules containing curcumin and/or methotrexate were prepared by an interfacial deposition of preformed polymer method. Methods Physicochemical properties, drug release experiments and in vitro cytotoxicity of these nanocapsules were performed against the Calu-3 lung cancer cell line. Results The colloidal suspensions of nanocapsules showed suitable size (287 to 325 nm), negative charge (-33 to -41 mV) and high encapsulation efficiency (82.4 to 99.4%). Spherical particles at nanoscale dimensions were observed by scanning electron microscopy. X-ray diffraction analysis indicated that nanocapsules exhibited a non-crystalline pattern with a remarkable decrease of crystalline peaks of the raw materials. Fourier-transform infrared spectra demonstrated no chemical bond between the drug(s) and polymers. Drug release experiments evidenced a controlled release pattern with no burst effect for nanocapsules containing curcumin and/or methotrexate. The nanoformulation containing curcumin and methotrexate (NCUR/MTX-2) statistically decreased the cell viability of Calu-3. The fluorescence and morphological analyses presented a predominance of early apoptosis and late apoptosis as the main death mechanisms for Calu-3. Conclusions Curcumin and methotrexate co-loaded nanocapsules can be further used as a novel therapeutic strategy for treating non-small-cell lung cancer.This work highlights new results on the synthesis of the TiAl3 intermetallic phase using self-propagating high-temperature synthesis. This method is considered a promising sintering route for intermetallic compounds. It was found that the reactions proceed in two stages. Below the melting point of aluminum, the Ti2Al5 phase forms at 450 °C after long annealing times by a direct solid-state reaction between the aluminum and titanium, and is converted consequently to TiAl3. This is a completely new finding; until now, many authors have believed in the preferential formation of the TiAl3 phase. The second stage, the self-propagating strongly exothermic reaction, proceeds above the melting point of aluminum. It leads to the formation of the TiAl3 phase accompanied by Ti2Al5 and Ti3Al phases. The reaction mechanism was shown in the form of chemical equations, which were supported by calculating Gibbs energy. Reaction temperatures (Tonset, Tmaximum, and Toffset) were determined after induction heating thanks to recording by an optical pyrometer. This finding provides completely new opportunities for the determination of activation energy at heating rates, in which common calorimeters are not able to detect a response or even measure. Now, the whole procedure will become accessible.The stability of emulsion liquid membranes (ELMs) and their ability to extract Cr(VI) were investigated. The objective of this study is to compare different ELM formulations using combinations of two hydrophilic (Tween 20 and Tween 80) and two lipophilic (polyglycerol polyricinoleate (PGPR) and Span 80) emulsifiers. TOPO (tri-n-octylphosphine oxide) as a carrier and a green solvent (sunflower oil) were used to provide high extraction efficiency of Cr(VI). All these double emulsions were characterized in droplet size distribution, zeta potential, visual inspection with a microscope, and stability. The best formulation was obtained with PGPR as the inner stabilizer and Tween 80 as the outer stabilizer, leading to Cr(VI) ion removal efficiency of up to 96%.We retrospectively analysed the data files of 171 adults and 87 children/adolescents with severe haemophilia, except for 14 patients (moderate; minor) (1), to develop a global population pharmacokinetic (PK) model for eight factors VIII (FVIII) that could estimate individual PK parameters for targeting the desired level of FVIII activity (FVIIIC); and (2) to compare half-life (HL) in patients switching from a standard half-life (SHL) to an extended half-life (EHL) and evaluate the relevance of the switch. One-stage clotting assay for the measurement of FVIII activity (FVIIIC, IU/mL) was used for population PK modelling. The software, Monolix version 2019R1, was used for non-linear mixed-effects modelling. A linear two-compartment model best described FVIIIC. The estimated PK parameters (between-subject variability) were 2640 mL (23.2%) for volume of central compartment (V1), 339 mL (46.8%) for volume of peripheral compartment (V2), 135 mL/h for Q (fixed random effect), and 204 mL/h (34.9%) for clearance (Cl). Weight, age, and categorical covariate EHL were found to influence Cl and only weight for V1. This model can be used for all of the FVIII cited in the study. Moreover, we demonstrated, in accordance with previous studies, that Elocta had longer half-life (EHL) than SHL (mean ratio 1.48) as compared to Advate, Factane, Kogenate, Novoeight, and Refacto.Composites comprised of Ag3PO4 and bare TiO2 (TiO2@Ag3PO4) or silver doped TiO2 (Ag@TiO2-Ag3PO4) have been synthesized by coupling sol-gel and precipitation methods. https://www.selleckchem.com/products/a-922500.html For the sake of comparison, also the bare components have been similarly prepared. All the samples have been characterized by X-ray diffraction (XRD), UV-vis diffuse reflectance spectroscopy (DRS), scanning electron microscopy (SEM), Fourier transformed infrared spectroscopy (FTIR), photoelectrochemical measurements, and specific surface area (SSA) analysis. The optoelectronic and structural features of the samples have been related to their photocatalytic activity for the degradation of 4-nitrophenol under solar and UV light irradiation. Coupling Ag3PO4 with silver doped TiO2 mitigates photocorrosion of the Ag3PO4 counterpart, and remarkably improves the photocatalytic activity under solar light irradiation with respect to the components, to the TiO2-Ag3PO4 sample, and to the benchmark TiO2 Evonik P25. These features open the route to future applications of this material in the field of environmental remediation.As organic dyes are a major source of pollution, it is important to develop novel and efficient heterogeneous catalysts with high activity for their degradation. In this work, two innovative techniques, atomic layer deposition and electrospinning, were used to prepare palladium nanoparticles (Pd NPs) supported on carbon nanofibers (CNFs). The sample morphology was investigated using scanning and transmission electron microscopy. This showed the presence of nanofibers of several micrometers in length and with a mean diameter of 200 nm. Moreover, the size of the highly dispersed Pd NPs was about 7 nm. X-ray photoelectron spectroscopy visually validated the inclusion of metallic Pd. The prepared nano-catalysts were then used to reduce methyl orange (MO) in the presence of sodium borohydride (NaBH4). The Freundlich isotherm model was the most suitable model to explain the adsorption equilibrium for MO onto the Pd/CNF catalysts. Using 5 mL MO dye-solution (0.0305 mM) and 1 mL NaBH4 (0.026 mM), a 98.9% of catalytic activity was achieved in 240 min by 0.